Toro Multi Pro 1200 - Page 210

Multi Pro 1200/1250Page 7 -- 48Drive Train
8. Assemble reduction shaft:
A. Apply moly disulfide grease to thrust washer
(item 16) and two (2) needle bearings (item 15).
Install washer, needle bearings and 47T gear (item
14)ontoreductionshaft(item3).Oilgrooveonwash-
er must face the gear.
B. Apply Dexron III ATF oil on cone face of gear
(item 14). Install synchro ring (item 13) onto gear.
C. Insert key (item 12) into reduction shaft slot.
D. Install synchro hub sub--assembly (item 11).
E. Install retaining ring (item 10).
F. Insertneedlebearing(item9)into40Tgear(item
8). Slide gear and bearing assembly onto shaft.
G. Installthrustwasher(item7).Oilgrooveonwash-
er must face the gear.
H. Use a press to install bearing (item 6) onto shaft.
I. Install 32T gear (item 5), collar (item 4) and 25T
gear (item 2) onto shaft.
J. Use a press to install bearing (item 1) onto s haft.
3
5
15
14
13
7
4
16
12
11
9
8
6
1
2
10
Figure 80
1
2
3
4
5
12
16
15
14
13
11
10
8
9
7
6
13
Figure 81
9. Assemble reverse shaft:
A. Install 33T gear (item 2) onto reverse shaft (item
4).
B. Use a press to install bearings (item 3 and 1).
1
2
3
4
Figure 82