Toro Multi Pro 1200 - Page 211

Multi Pro 1200/1250 Page 7 -- 49 Drive Train
10.Assemble main shaft:
A. Install 20T gear (item 17) and retaining ring (item
16).
B. Install 14T gear (item 15).
C. Useapresstoinstallbearing( item14)ontoshaft.
D. Apply moly disulfide grease onto thrust washer
(item 13) and two (2) needle bearings (item 12).
Install washer and needle bearings onto main shaft.
Oil groove on washer must face the gear.
E. Install 22Tgear (item 11) and retaining ring (item
10).
F. Apply Dexron III ATF oil on cone face of gear
(item 11). Install synchro ring (item 6) onto gear.
G. Insert key (item 9) into main shaft slot.
H. Install synchro hub sub--assembly (item 8).
I. Install retaining ring (item 7).
J. Apply Dexron III ATFoil to cone face of 36T gear
(item 4). Install synchro ring (item 6) onto gear.
K. Apply moly disulfide grease onto two (2) needle
bearings (item 5). Insert needle bearings into gear
(item 4).
L. Install gear (item4) with synchro ring and needle
bearings onto main shaft.
M. Apply moly disulfide grease to thrust washer
(item 3). Install washer and snap ring (item 2) to
shaft. Oil groove on washer must face the gear.
N. Use a press to install bearing (item 1) onto shaft.
1
2
3
5
4
6
8
13
15
7
10
11
12
9
18
17
16
14
Figure 83
1
2
3
5
4
6
8
7
10
6
11
12
13
9
18
17
16
15
14
Figure 84
Drive Train