Toro Multi Pro 1200 - Page 218

Multi Pro 1200/1250Page 7 -- 56Drive Train
21.Install differential gear assembly (item 2) into trans-
axle case.
22.Inserttwo(2)dowelpins(item1)intotransaxlecase.
2
1
1
Figure 100
23.Install side c over:
A. Thoroughly clean mating surfaces of transaxle
caseandsidecover.Applysiliconesealantontomat-
ing surface of side cover.
B. Install side cover and secure with cap screws.
Torque cap screws from 18 to 22 ft--lb (24.5 to 29.5
N--m).
18 to 22 ft--lb
(24.5 to 29.5 N--m)
NOTE: This
used on
shaft not
Multi Pro
Figure 101
24.Install R.H. axle shaft assembly:
A. Thoroughly clean mating surface of transaxle
caseandsealcoverofR.H.axleshaftassembly.Ap-
ply silicone sealant onto mating surface of seal cov-
er.
B. Install axle shaft assembly (item 2) and secure
withcapscrews.Torquecapscrews(item1)from18
to 22 ft--lb (24.5 to 29.5 N--m).
18 to 22 ft--lb
(24.5 to 29.5 N--m)
2
1
Figure 102