Toshiba B-EX6T Series - Page 129

128
・ HF band(H2) B-EX700-RFID-H2-R
B-EX700-RFID-H3-QM-R
・ UHF band (U2/U4) B-EX700-RFID-U2-EU-R (Europe,India)
B-EX700-RFID-U2-US-R (U.S.A, Australia, Taiwan, Korea)
B-EX700-RFID-U4-R (Japan)
B-EX700-RFID-U4-EU-R (Europe)
B-EX700-RFID-U4-US-R (Korea)
B-EX700-RFID-U4-AU-R (Australia)
U4 module preinstall model
(B-EX4T1/T2-GS18/TS18-CN-R) (China)
Note: This setting will become effective after the printer power is turned off, and back to on.
9.10.2.2 COUNTRY
When the module type is set to “U4”, the country code of the currently installed module is displayed.
If the module type is set to other than “U4”, “INVALID” is displayed.
It is possible to change the country setting only when the module type is set to “U4” and the actually installed
module is US or EU or AU. However, this menu is password-protected because changing the country setting
causes the output frequency to change.
The following message is displayed depending on the module type setting, the mounted module type, and the
module mount condition.
B-EX6T1/T3
Module Type
parameter
Module type and status
Message
NONE
No module installed.
NONE
U2/U4
No module installed.
No RFID Module
B-EX706-RFID-U4-R
B-EX706-RFID-U4-EU-R
B-EX706-RFID-U4-US-R
B-EX706-RFID-U4-AU-R
No country
setting
Need Setting for use
[ENTER] for Setting
B-EX4T1
Module Type
parameter
Module type and status
Message
NONE
No module installed.
NONE
H1
H2
B-EX700-RFID-H1-QM-R
B-EX700-RFID-H2-R
B-EX700-RFID-H3-QM-R
INVALID
U2/U4
No module installed.
No RFID Module
B-EX700-RFID-U2-EU-R
B-EX700-RFID-U2-US-R
B-EX700-RFID-U4-R
B-EX700-RFID-U4-EU-R
B-EX700-RFID-U4-US-R
B-EX700-RFID-U4-AU-R
U4 module preinstall model
Set the country
[ENTER] for Setting
No country
setting
Need Setting for use
[ENTER] for Setting