e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 14
EAE0 Finisher jam Receiving time-out jam: The printing has been
interrupted because of the communication error
between the equipment and finisher when the
paper is transported from the equipment to the
finisher.
P. 8-136
EAF1 Stack exit roller nip motor home position detection
error: The detection of the home position of the
stack exit roller nip motor ends abnormally. This
error may occur if paper is jammed while being
transported, so it is treated as a paper jam.
[MJ-1032/MJ-1033]
-
EAF2 Stapler unit sliding motor home position detection
error: The detection of the home position of the
stapler unit sliding motor ends abnormally. This
error may occur if paper is jammed while being
transported, so it is treated as a paper jam.
[MJ-1032/MJ-1033]
-
EAF3 Gripper arm motor home position detection error:
The detection of the home position of the gripper
arm ends abnormally. This error may occur if paper
is jammed while being transported, so it is treated
as a paper jam. [MJ-1033]
P. 8-137
EB30 Ready time-out jam: The equipment judges that the
paper transport to the finisher is disabled because
of the communication error between the equipment
and finisher at the start of printing.
P. 8-137
EB50 Paper transport jam Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper.
P. 8-79
EB60 Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper (redetection after no jam is
detected at [EB50]).
P. 8-82
ED10 Finisher jam
(Finisher section)
Skew adjustment motor (M1) home position
detection abnormality: The Skew adjustment motor
is not at the home position. [MJ-1101/1106 (when
MJ-6103 is installed), MJ-1107/1108 (when MJ-
6104 is installed)]
P. 8-137
ED11 Sideways adjustment motor (M2) home position
detection error: The Sideways adjustment motor is
not at the home position. [MJ-1101/1106 (when MJ-
6103 is installed), MJ-1107/1108 (when MJ-6104 is
installed)]
P. 8-138
ED12 Shutter home position error: The shutter is not at
the home position. [MJ-1101/1107/MJ-1106/1108]
P. 8-138
ED13 Front alignment plate home position error: The front
alignment plate is not at the home position. [MJ-
1101/1107/MJ-1106/1108]
P. 8-139
ED14 Rear alignment plate home position error: The rear
alignment plate is not at the home position. [MJ-
1101/1107/MJ-1106/1108]
P. 8-140
ED15 Paddle home position error: The paddle is not at the
home position. [MJ-1101/1107/MJ-1106/1108]
P. 8-141
ED16 Buffer tray home position error: The buffer tray is
not at the home position. [MJ-1101/1107/MJ-1106/
1108]
P. 8-142
Error code Classification Contents Troubleshooting
To Next Page
Loading...
