3
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
OUTLINE OF THE MACHINE
3 - 55
[ 2 ] Recovered process unit mechanism
The process unit of this equipment has two types; one is for the 20ppm/25ppm/30ppm and another is
for the 35ppm/45ppm/50ppm.
The differences between two are shown below.
Be sure not to install the process unit to a wrong model when replacing them because they are
incompatible each other.
To distinguish them, check the position of the bracket hole seen from the back side.
Fig. 3-34
Parts 20ppm/25ppm/30ppm 35ppm/45ppm/50ppm
Toner recovery roller Not installed Installed
Gear, belt For low speed For high speed
Discharge LED 10 LEDs 14 LEDs
Needle electrode For low speed For high speed
Position of bracket hole
(seen from the back side)
Bottom Top
Discharge LED
Needle
electrode
Gear, Belt
Toner recovery roller
20ppm/25ppm/30ppm 35ppm/45ppm/50ppm
To Next Page
Loading...
