e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
3 - 20
3.6 GENERAL OPERATION
3.6.1 Overview of Operation
3.6.2 Description of Operation
[ 1 ] Warming-up
1. Initialization
Power ON
Heater lamp ON
Set number “1” reproduction ratio “100%” and “WAIT WARMING UP” are displayed
Fan motors ON
Initialization of scanning system
- The carriage moves to the home position.
- The carriage moves to the peak detection position.
- The exposure lamp is turned ON.
- Peak detection (white color is detected by the shading correction plate)
- The exposure lamp is turned OFF.
“READY (WARMING UP)” is displayed
2. Pre-running operation
The pre-running operation is started when the temperature of the fuser roller surface reaches a
certain temperature.
The main motor is turned ON.
- Fuser roller rotated
- Drum rotated
Initialization of feeding system
- Each drawer tray goes up.
Pre-running operation stops after three seconds.
3. When the surface temperature of the fuser roller becomes sufficient for fusing,
“READY” is displayed.
[ 2 ] Ready state (ready for copying)
Buttons on the control panel enabled
When no button is pressed for a certain period of time,
- Set number “1” and reproduction ratio “100%” are displayed. Equipment returns to the normal
ready state.
Operation of equipment Operation during initializing, pre-running and ready
Copying operation
Drawer feed copying by [START] button
Bypass feed copying
Interrupt copying
To Next Page
Loading...
