e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 28
6.4.8 Adjustment of image density
The image density level can be set at the following codes.
< 05 Adjustment Mode >
<Procedure>
(1) Performs FS-05.
(2) Key in a code and press the [START] button.
(3) Key in the sub code (0, 1, 2, 3 or 4), and press the [START] button.
(4) Key in an adjustment value.
(To correct the keyed-in value, press the button.)
(5) Press the [OK] button to store the value in memory. The equipment goes back to the ready state.
(6) For resetting the value, repeat step (2) to (5).
(7) Press the [TEST COPY] button and then select an original mode. Then press the [START] button
to perform test copying.
(8) If the desired image density has not been attained, repeat step (2) to (7).
Code
Item to be adjusted Remarks
Text/
photo
Text Photo
7218-0
to 4
7219-0
to 4
7220-0
to 4
Adjustment of image
density
When the value is decreased, text becomes lighter.
Acceptable values: 0 to 10
Notes:
1. Set not to reverse the large and small
number of the setting value
corresponding to the sub code.
Ex.) When the image density level for
7218-0, 7218-1, 7218-2, 7218-3, and
7218-4 is assumed to be “A”, “B”, “C”,
“D”, and “E” respectively, they should
have the following correlation:
2. Remember that the image
specifications and life span of the
replacing parts may not meet the
standard when the setting value is
changed from the default value.
To Next Page
Loading...
