8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 325
8.4.6 Poor fusing
Fig.8-8
Defective area Step Check items Prescription
Heater electric power 1 Check if the connector contacts
properly.
Correct it.
2 Is the heater shorted or broken? Replace the heater.
Pressure between fuser
roller and pressure roller
3 Are the pressure springs working
properly?
Check and adjust the pressure
springs.
Fuser roller temperature 4 Is the temperature of the fuser roller
normal?
Check the setting and correct it.
08-2120, 2010, 2009, 2140, 515, 516
(08-5285: Only e-STUDIO356/456/
506 / e-STUDIO357/457/507)
Developer material/Toner 5 Using the specified developer
material and toner?
Use the specified developer material
and toner.
Paper 6 Is the paper in the drawer or LCF
damp?
Avoid storing paper in damp place.
7 Is the paper type corresponding to its
mode?
Use the proper type of paper or
select the proper mode.
8 Is the setting temperature of the fuser
roller in each paper type normal?
Check the setting and correct it.
08-2028, 2049, 2050, 2051,2141,
2142, 2143, 2192, 2194, 2195)
(08-5328, 5329, 5330, 5331, 5332: e-
STUDIO356/456/506 / e-
STUDIO357/457/507)
9 Using the recommended paper? Use the recommended paper.
To Next Page
Loading...
