8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 331
8.4.11 Skew (inclined image)
Fig.8-14
Defective area Step Check items Prescription
Drawers
LCF
1 Is the drawer or LCF properly
installed?
Install the drawer or LCF properly.
2 Is there too much paper in the drawer
or LCF?
Reduce paper to 550 or fewer sheets
in the drawer. Reduce paper to 1000
or fewer sheets in the feeding side
tray and the standby side tray of LCF,
respectively.
3 Is the corner of the paper folded? Change the direction of the paper
and set it again.
4 Are the side guides of the drawer or
LCF properly installed?
Adjust the position of the side guides.
Feed roller 5 Is the surface of the feed roller dirty? Clean the feed roller surface with
alcohol, or replace the roller.
Rollers 6 Are the roller and shaft secured? Check and tighten the E-rings, pins,
clips and setscrews.
Registration roller 7 Is the spring detached from the
registration roller?
Attach the spring correctly. Clean the
roller if it is dirty.
Pre-registration guide 8 Is the pre-registration guide properly
installed?
Correct it.
Scanner 9 Is the carriage-1 slanted? Adjust the carriage-1.
To Next Page
Loading...
