Toshiba E-STUDIO3508A - 6.14.4 Adjusting Paper Exit Speed

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 80
6.14.4 Adjusting Paper Exit Speed
[ 1 ] Adjusting procedure
[ 1-1 ] DIP switch settings
(1) Turn OFF the power of the equipment.
(2) Remove 1 screw and take off the board access cover [1].
(3) Set the SW1 on the Finisher control board as shown in the figures below.
Fig.6-85
(4) Turn ON the power of the equipment while [FUNCTION CLEAR] button and [START] button are
pressed simultaneously.
ON
SW1
1 2 3 4
SW1
[1]