6
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
6 - 79
B4-size recycled paper mode
Notes:
To change settings from the B4-size recycled paper mode to the normal mode, perform steps (1)
through (4), and then press [Button1] and [Button2] on the control panel as shown below to set
the normal mode.
Normal mode
(6) When the settings are stored normally, [LED1] on the control panel is lit. [LED1] blinks, if an error
occurs. In this case, turn the power OFF and make the settings again from step (4).
(7) Turn OFF the power of the equipment.
(8) Turn OFF all bits of the SW1 on the Finisher control board.
(9) Install the board access cover.
Step Buttons Number of pressing Remarks
1 Button1 1
2 Button2 1 Confirms the input value
3 Button1 8
4 Button2 1 Confirms the input value
Step Buttons Number of pressing Remarks
1 Button1 1
2 Button2 1 Confirms the input value
3 Button1 6
4 Button2 1 Confirms the input value
To Next Page
Loading...
