Toshiba E-STUDIO3508A - 6.7.2 Adjustment of image density

To Next Page

To Previous Page

SETTING / ADJUSTMENT

6 - 41

6.7.2 Adjustment of image density

The image density level can be set at the following codes.

< 05 Adjustment Mode >

(1) Performs FS-05.

(2) Key in the code and press the [START] button.

(3) Key in the sub code and press the [START] button.

(4) Key in an adjustment value.

(To correct the keyed-in value, press the button.)

(5) Press the [OK] button to store the value in memory. The equipment goes back to the ready state.

(6) For resetting the value, repeat step (2) to (5).

(7) Turn the power OFF.

Check the beam level conversion setting with the actual fax data received, if possible.

Code Item to be adjusted Remarks

7595-0 to 4 Adjustment of image density When the value is decreased, text becomes lighter.

Acceptable values: 0 to 10

Notes:

1. Set not to reverse the large and small

number of the setting value corresponding

to the sub code.

Ex.) When the image density level for 7595-

0, 7595-1, 7595-2, 7595-3, and 7595-4 is

assumed to be “A”, “B”, “C”, “D”, and “E”

respectively, they should have the following

correlation:

Remember that the image specifications

and life span of the replacing parts may not

meet the standard when the setting value is

changed from the default value.

B C D E

Other manuals for Toshiba E-STUDIO3508A