Toshiba E-STUDIO3508A - 4.5.8 Registration roller (on the equipment side)

4
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
4 - 51
4.5.8 Registration roller (on the equipment side)
(1) Remove the registration roller clutch.
 P. 4-80 "4.5.37 Registration roller clutch
(CLT1)"
(2) Open the side cover.
(3) Remove the clip [2] from the registration
roller [1].
Fig. 4-136
(4) Slide the registration roller [1] to the rear
side, and then remove 1 bushing [3] on the
front side. Remove the registration roller [1].
Fig. 4-137
(5) Remove 1 stopper [4], 1 E-ring [5], 1 pin [6]
and 1 gear [7] from the registration roller [1].
Fig. 4-138