Toshiba E-STUDIO3508A - 6.3 Image Dimensional Adjustment; 6.3.1 General description

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 4
6.3 Image Dimensional Adjustment
6.3.1 General description
There are several adjustment items in the image dimensional adjustment, as listed below. When
adjusting these items, the following adjustment order should strictly be observed.
Item to be adjusted Code in 05 Adjustment Mode
1 Paper alignment at the registration roller
4100, 4101, 4103, 4104, 4105,
4106, 4107,4108, 4109, 4110,
4111, 4115, 4116, 4117, 4118,
4119, 4120
2 Printer related
adjustment
(a) Reproduction ratio of primary scanning
direction
(Fine adjustment of polygonal motor rotation
speed)
4001
(b) Primary scanning data laser writing start
position
4006
(c) Reproduction ratio of secondary scanning
direction
(Fine adjustment of main motor rotation
speed)
4009
(d) Secondary scanning data laser writing start
position
4058, 4059, 4060, 4061, 4062,
4063
(e) Primary scanning data laser writing start
position
at duplexing
4019
3 Scanner
related
adjustment
(a) Image distortion
3033
(b) Reproduction ratio of primary scanning
direction
4000
(c) Image location of primary scanning direction
3030
(d) Reproduction ratio of secondary scanning
direction
3032
(e) Image location of secondary scanning
direction
3031
(f) Top margin
4050
(g) Right margin
4052
(h) Bottom margin
4053