Toshiba E-STUDIO3508A - Page 389

6
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
6 - 5
[Procedure to key in adjustment values]
In accordance with the procedure described below, make adjustment of each adjustment item so that
the measured values obtained from test copies satisfy the specification. By pressing the [TEST COPY]
button, immediately after starting the 05 Adjustment Mode, single-sided test copying can be performed
(normal copy mode).
Fig.6-6
100% A
A3
TEST MODE
100% A
A3
TEST MODE
100% A
A3
Wait Warming Up
100% A
A3
COPYING
100% XXX
A3
TEST MODE
YYY ZZZ
Current adjustment value
Adjustment value newly keyed in.
(If no entering, YYY is displayed.)
Code No.
1
POWER
OK
Digital keys
START
: Key in codes.
<Operation keys> <Display>
Power OFF/ON
: Exit the Adjustment Mode.
Test copy
Digital keys
TEST COPY
START
: Key in adjustment
values.
Value ZZZ is stored
replacing values YYY.
If the test copy does not
satisfy the specified values,
return to step 1 and
repeat the adjustment
procedure.
( CLEAR Use to make corrections)
FS
05