6
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
6 - 31
6.5.2 Adjustment of image density
The image density when normal printing is performed while [Toner Save] and [Hardcopy Security Kit]
are selected from a printer driver can be adjusted.
< 05 Adjustment Mode >
<Procedure>
(1) Performs FS-05.
(2) Key in a code and press the [START] button.
(3) Key in the sub code (0, 1, 2, 3 or 4), and press the [START] button.
(4) Key in an adjustment value.
(To correct the keyed-in value, press the [CLEAR] button.)
(5) Press the [OK] button to store the value in memory. The equipment goes back to the ready state.
(6) For resetting the value, repeat step (2) to (5).
(7) Turn the power OFF and then back ON to perform printing job.
(8) If the desired image density has not been attained, repeat step (2) to (7).
Normal
Print
Toner mode
Hardcopy
security
printing
Item to be
adjusted
Remarks
Toner
save
(PS)
Toner
save
(PCL)
Toner
save
(XPS)
7350-0
to 4
7351-0
to 4
7352-0
to 4
7353-0
to 4
7354-0 to 4 Adjustment of
image density
When the value is decreased, text
becomes lighter.
Acceptable values: 0 to 10
Notes:
1. Set not to reverse the large and
small number of the setting
value corresponding to the sub
code.
Ex.) When the image density
level for 7350-0, 7350-1, 7350-
2, 7350-3, and 7350-4 is
assumed to be “A”, “B”, “C”,
“D”, and “E” respectively, they
should have the following
correlation:
2. Remember that the image
specifications and life span of
the replacing parts may not
meet the standard when the
setting value is changed from
the default value.
To Next Page
Loading...
