Toshiba E-STUDIO3508A - 4.11.5 Exit motor (M10)

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 142
4.11.5 Exit motor (M10)
(1) Remove the right rear cover.
 P. 4-4 "4.1.10 Right rear cover"
(2) Remove the paper exit unit.
 P. 4-139 "4.11.2 Paper exit unit <35ppm/
45ppm/50ppm>"
(3) Remove the connecting port cover.
 P. 4-3 "4.1.7 Connecting port cover"
(4) Remove 1 screw and take off the exit motor
assembly [1].
Fig. 4-380
(5) Disconnect 1 connector from the exit motor
assembly [1].
Fig. 4-381
(6) Remove the belt [2].
Fig. 4-382