e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 188
4.13.9 MJ-6105 with MJ-1110 (Hole punch unit)
(7) Open the finisher cover and remove 1 fixing
screw. Pull out the lever.
Fig. 4-513
(8) Remove the finisher.
Fig. 4-514
(1) Press the [Power] button on the control panel
to shut it down.
(2) Turn the main power switch of the equipment
off.
(3) Disconnect the power cable.
(4) Remove the connector cover.
Fig. 4-515
To Next Page
Loading...
