e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 50
(9) Take off the paper guide [6] by sliding it
toward the front side.
Fig. 4-133
(10) Release 2 latches and remove the sensor
bracket [7].
Fig. 4-134
(11) Disconnect 2 connectors. Remove the 1st
transport sensor [8] and registration sensor
[9].
Notes:
When installing connectors, connect the
black wire harness to the 1st transport
sensor [8], and the blue wire harness to the
registration sensor [9].
Fig. 4-135
To Next Page
Loading...
