5
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SELF-DIAGNOSTIC MODE
5 - 43
Fig.5-27
1. LOW (Normally use this setting.)
This is the standard overwriting method.
"00-FF-Random-Verify" Once
2. MEDIUM
This overwriting method is more secure than LOW. The erasing time is between LOW and HIGH.
"00-FF-Random" three times repeatedly -Verify
3. HIGH
This is the most secure overwriting method. It takes the longest time to erase data.
"00-FF-Random" five times repeatedly -Verify
4. SIMPLE
This is the simple overwriting method. It takes the shortest time to erase data.
Overwrite the Random data once
The reconfirmation screen is displayed when the icon is pressed.
Press [OK]: Processing starts.
Press [Back]: The screen returns to the previous one.
Notes:
When this operation has been done, do not perform SRAM data formatting (Clear SRAM)
before the normal start-up.
[G] Erasing SRAM securely (Erase SRAM Securely)
This function is used before discarding the SRAM board (for the SYS board).
It overwrites all the used areas on the SRAM board with the selected data, and makes it unusable.
Immediately after selecting this function, the processing starts and is completed.
[H] Clearing service tech password (Clear Service Tech)
This function is needed after the HDD is replaced.
When the HDD is replaced, the service tech password stored in the new one is set as a blank.
Therefore, its password is copied to the SRAM board so that both passwords become the same with
this function. The setting is enabled when the equipment is started up in the normal mode after
performing this function.
Firmware Assist Mode (3C)
HDD Secure Erase modeFirmware Assist Mode (3C) status
Select any of the Below Options
Back
LOW MEDIUM HIGH SIMPLE
To Next Page
Loading...
