6
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
6 - 11
[D] Secondary scanning data laser writing start position
This adjustment has to be performed for each paper source. (If there is no paper source, skip this step.)
The following table shows the order of the paper source to be adjusted, code, paper size and
acceptable values.
<Procedure>
(1) Performs FS-05. (05 Adjustment Mode)
(2) Press [1] ([3] for duplexing) [TEST PRINT]. (A grid pattern with 10 mm squares is printed out.)
(3) Check the grid pattern on the test chart printed out and measure the distance D from the leading
edge of the paper to the 6th line of the grid pattern.
* Normally, the 1st line of the grid pattern is not printed.
* At the duplexing, measure it on the top side of the grid pattern.
(4) Check if the distance D is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance D again.
FS-05 (Key in the code shown above) [START]
(Key in an acceptable value shown above)
[OK] (Stored in memory)
“100% A” is displayed
Press [1] ([3] for duplexing) [TEST PRINT] (A grid pattern is printed out.)
* The larger the adjustment value is, the shorter the distance D becomes (approx. 0.1 mm/
step).
Order for
adjustment
Paper source Code Paper size
Acceptable
value
Remarks
1 Lower drawer 4059 A3/LD 0 to 40
2 Upper drawer 4058 A4/LT 0 to 15
3 PFP 4060 A4/LT 0 to 15
4 Bypass feed 4061 A4/LT 0 to 15
5 Duplexing 4062 A3/LD 0 to 15 Paper fed from the lower drawer
To Next Page
Loading...
