e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 22
[H] Bottom margin
<Procedure>
(1) Performs FS-05. (Adjustment Mode)
(2) Open the original cover or RADF.
(3) Press [TEST COPY] [START] to make a copy at the mode of A3/LD, 100%, Text/Photo and
the lower drawer (Refer to *).
(4) Measure the blank area G at the trailing edge of the copied image.
(5) Check if the blank area G is within the range of 4.2 ± 1.0 mm.
(6) If not, use the following procedure to change values and repeat the steps (3) to (5) above.
FS-05 Key in the code [4053] [START]
(Key in value (acceptable values: 0 to 255))
Press the [OK] button (stored in memory).
(“100% A” is displayed.)
* The larger the adjustment value is, the wider the blank area at the trailing edge becomes
(approx. 0.04 mm/step).
Fig.6-18
To Next Page
Loading...
