6
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
6 - 61
(8) Install the right-hand hinge screw at the rear
side.
Fig.6-58
(9) Loosen the hinge screws at the front side.
Fig.6-59
(10) Place the platen sheet on the original glass
and align it to the top left corner.
Close the RADF gently and open it to check
if the platen sheet is attached properly.
Fig.6-60
MR-3028
To Next Page
Loading...
