6
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
6 - 63
[B] Adjustment
(1) Close the RADF.
(2) Adjust it by turning the adjustment screws on the hinges.
• Adjust the height on the rear side by means of the screw on the hinge on the feed side of the
RADF.
Fig.6-62
• Adjust the gap on the rear side by means of the screw on the hinge on the feed side of the
RADF.
Fig.6-63
Turn it clockwise ...................... Heightened
Turn it counterclockwise ........... Lowered
Turn it clockwise ...................... Lowered
Turn it counterclockwise ........... Heightened
To Next Page
Loading...
