e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 80
When the paper is fed from the bypass tray:
Proce
dure
Check item Result Measure
Next
Step
1
ADU Open the ADU and remove paper if there is
any on the transport path.
2
2
Is the 1st transport sensor
working? (Perform the
input check: 03-[FAX]/
OFF/[6]/[A])
Yes
3
No
4
3
Is the registration sensor
working? (Perform the
input check in the test
mode: 03-[FAX]ON/[9]/[A])
Yes Check the rollers. Replace them if they are
worn out
No
5
4
LGC board 1. Check if the connector CN316 on the LGC
board is disconnected.
2. Check if the connector pins are
disconnected or the harnesses are open
circuited.
3. Check if the conductor patterns on the LGC
board are short circuited or open circuited.
4. Replace the 1st transport sensor.
5. Replace the LGC board.
5
LGC board, registration
sensor
1. Check if the connector CN316 on the LGC
board is disconnected.
2. Check if the connector pins are
disconnected or the harnesses are open
circuited.
3. Check if the conductor patterns on the LGC
board are short circuited or open circuited.
4. Replace the registration sensor.
5. Replace the LGC board.
Parts to be replaced Remark
1st transport sensor
LGC board
Registration sensor
Rollers on the transport path
To Next Page
Loading...
