e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
3 - 22
[ 4 ] Bypass feed copying
1. Insert a sheet of paper into the bypass tray.
Bypass paper sensor ON
- “Ready for bypass feeding” is displayed.
2. Press the [START] button
“Ready for bypass feeding” changes to “COPYING”
Exposure lamp ON
Scan motor ON Carriages -1 and -2 move forward
Polygonal motor rotates in high speed
Main motor and exit motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
3. Bypass feeding
Main charger, developer bias and discharge LED ON. Fans are rotated in high speed.
Bypass feed clutch ON
- The bypass feed roller start to rotate.
Aligning operation
Paper reaches the registration roller
After a certain period of time, the bypass feed clutch OFF
4. Hereafter, the operation 3) through 6) of P. 3-21 "[ 3 ] Drawer feed copying (1st drawer paper
feeding)" is repeated.
[ 5 ] Interruption copying
1. Press the [INTERRUPT] button
LED “INTERRUPT” ON
Copying operation in progress is temporarily stopped. Carriages -1 and -2 return to appropriate
positions.
“Job interrupted job 1 saved” is displayed.
Automatic density and reproduction ratio 100% are set (The set number remains the same)
2. Select the desired copy condition
3. After the interruption copying is finished:
LED “INTERRUPT” OFF by pressing the [INTERRUPT] button
Equipment returns to the status before the interruption
“Ready to resume job 1” is displayed
4. Press the [START] button
The copying operation before the interruption is resumed.
To Next Page
Loading...
