8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 143
[EF10] Paper not supported for Saddle Stitch Finisher
MJ-1106/1108
[EF11] Saddle Stitch Finisher stapling error (front)
MJ-1106/1108
Classification Error item
Finisher jam (Finisher section) Unsupported paper size, type and an excess number of
pages for stapling are selected.
Check item Measures
Paper • Paper size check
Buffer tray home position sensor • Sensor check
• Connector check
• Harness check
Buffer tray guide motor • Motor check
• Connector check
• Harness check
Saddle controller board • Connector check
• Board check
Parts to be replaced Remark
Buffer tray home position
sensor
Buffer tray guide motor
Saddle controller board
Classification Error item
Finisher jam (Saddle section) Front stapling is not correctly done.
Check item Measures
Finisher • Is there any paper remaining on the paper transport path
in the Finisher or the equipment, or on the finishing tray?.
Saddle staple cartridge (Front side) • Is the jam released by taking off the front staple cartridge
from the Finisher and removing the staple sheet slid from
the staple case?
Front saddle stapler drive unit • Unit check
• Connector check
• Harness check
Saddle controller board • Connector check (CN3)
• Board check
Replace parts Remarks
Front saddle stapler drive unit
Saddle controller board
To Next Page
Loading...
