8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 161
[C270] Carriage home position sensor not going OFF within the specified time (e-STUDIO207L/
257/307/357/457/507)
Remove the original glass and move the carriages to the paper feeding side. Turn ON the power and
check the following items.
Classification Error content
Scanning system related service
call
The carriage does not shift from its home position in a specified
period of time. / Abnormal carriage home position sensor.
Check item Measure
1 Carriage home position
sensor
1. Check if the harness of the carriage home position sensor is
connected properly.
2. Check if the harness has any scratch on it or is open
circuited or caught anywhere.
3. Check if there is any abnormality in the carriage home
position sensor.
4. Replace the carriage home position sensor.
5. Replace the harness.
SYS board 1. Check if the harness (CN127) of the carriage home position
sensor is connected properly.
2. Check if there is any abnormality in the parts mounted on the
SYS board.
3. Check if 24V on the SYS board is short circuited.
4. Check if 24V is supplied to the SYS board.
5. Check if there is any abnormality in the parts mounted on the
SYS board.
6. Replace the SYS board.
Scan motor 1. Check if the belt tension is loosened.
2. Check if the motor fixing screw is loosened.
3. Check if the carriage wire and the timing belt come off.
4. Check if the connector is connected to the scan motor
properly.
5. Check if the harness of the scan motor has any scratch on it
or is open circuited or caught anywhere.
6. Replace the scan motor or the harness.
2 carriage lock 1. Check if the carriage locking is released.
3 Setting Clear the SRAM data by starting the equipment in the 3C mode,
and initialize them in the 08 mode.
(Refer to P. 9-25 "9.2.8 Precautions and procedure when
replacing the SRAM").
Parts to be replaced Remark
Carriage home position sensor
Carriage home position sensor
harness
SYS board
Scan motor
Scan motor harness
To Next Page
Loading...
