8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 217
MJ-1106/1108
[CF10] Communication module SRAM reading failure
MJ-1101/1107
MJ-1101 (When MJ-6103 is installed) / MJ-1107 (When MJ-6104 is installed)
Check Item Measure
Paddle Rotate the paddle.
Fix any mechanical problem.
Paddle motor (M8) Check if the connector (CN22) on the finisher controller PC
board is disconnected from the paddle motor (M3) and the
harnesses are open circuited. Correct if so.
Replacement part Measure
Paddle motor (M8)
Finisher control PC board
Classification Contents
Finisher related service call Communication module SRAM reading failure.
Check Item Measure
Main power switch Turn OFF the main power switch, then back ON.
Setting of the equipment Check if the MJ-1101/1107 is set as the specified finisher on the
equipment. (08-4548)
Converter PC board • Check the connectors and harnesses between the converter
PC board and the finisher controller PC board.
• Board check
Finisher control PC board Board check
Replacement part Measure
Converter PC board
Finisher control PC board
Check Item Measure
Main power switch Turn OFF the main power switch, then back ON.
Setting of the equipment Check if the MJ-1101/1107 is set as the specified finisher on the
equipment. (08-4548)
Converter PC board • Check the connectors and harnesses between the converter
PC board and the finisher controller PC board.
• Board check
Finisher control PC board • Check the connectors and harnesses between the hole
punch control PC board and the finisher control PC board.
• Board check
Hole punch control PC board Board check
Replacement part Measure
Converter PC board
Finisher control PC board
Hole punch control PC board
To Next Page
Loading...
