e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 228
[F102] HDD start error
[F103] HDD transfer time-out
[F104] HDD data error
[F105] HDD other error
[F106_0] ADI-HDD error: Illegal disk replacement detected (ADI-HDD Exchange to SATA-HDD)
Classification Contents
Other service call HDD unmounted: Connection of HDD cannot be detected.
HDD start error: HDD cannot become “Ready” state.
HDD transfer time-out: Reading/writing cannot be performed in
the specified period of time.
HDD data error: Abnormality is detected in the data of HDD.
HDD other error
Check Item Measure
HDD • Connector and harness check
• Check if the connector pins of the HDD are bent.
• Perform the bad sector check (08-9072). If the check result
is OK, recover the data in the HDD. If the check result is
failed, replace the HDD.
Replacement part Remark
HDD
SYS board
Classification Error item
Other service call
ADI-HDD error: The ADI-HDD has been replaced illegally to
SATA-HDD (normal type).
Check Item Measure
Setting Check if the HDD has been replaced with a SATA-HDD
(normal type).
(1) Start the equipment in the 4C mode: [4] + [C] +
[POWER]
(2) Check the type of the HDD shown on the top left of
the control panel display “Current HDD type”.
2a. In case of “SATA-HDD” (normal type), replace it with the
original ADI-HDD or a new ADI-HDD.
Notes:
To replace with the original ADI-HDD, start the
equipment in the normal mode and then reinstall
master data (HD Data) only if any abnormality
occurs.
2b. In case of “ADI-HDD”
Check each item in the Measures field for the HDD
below.
If the error still occurs, reinstall the master data (HD
Data).
To Next Page
Loading...
