e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 230
[F106_3] ADI-HDD error: ADI authentication Admin Password generation error
[F106_4] ADI-HDD error: Authentication random number generation error
Check Item Measure
Setting Checking of ADI-HDD encryption key status
(1) Start the equipment in the 3C mode: [3] + [C] +
[POWER]
(2) The authentication menu is displayed. Press [OK].
(Not required in the default setting)
(3) Select “5. Key Backup Restore” and then press the
[START] button.
(4) Check the status of the ADI-HDD encryption key on
the Key Backup Restore Mode menu.
(5) After the operation is completed, shut down the
equipment by pressing the [POWER] button.
• In case both the SRAM ADIKey and FROM ADIKey
status are OK
Reinstall the system ROM data (OS Data).
• In case either the SRAM ADIKey or FROM ADIKey
status is other than OK
Restore the ADI-HDD encryption key.
• In case both of the SRAM ADIKey or FROM ADIKey
status are other than OK
Reinstall the master data (HD Data).
HDD If the error persists even after above step , replace the
HDD. If the equipment operation disabled after above step,
replace the HDD.
Classification Error item
Other service call
ADI-HDD error: The generation of ADI authentication
Admin Password fails.
Check Item Measure
Setting Reinstall the system ROM data (OS Data).
Reinstall the master data (HD Data).
HDD If the error persists even after above step , replace the
HDD. If the equipment operation disabled after above step,
replace the HDD.
Classification Error item
Other service call ADI-HDD error: The generation of a random number for
authentication data fails.
Check Item Measure
Setting Reinstall the system ROM data (OS Data).
Reinstall the master data (HD Data).
HDD If the error persists even after above step , replace the
HDD. If the equipment operation disabled after above step,
replace the HDD.
To Next Page
Loading...
