9
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
REPLACEMENT OF PC BOARDS/HDD
9 - 3
Notes:
• When removing the flat cables [4], pull out
the flat cables [4] while pushing the actuators
[5].
• When connecting the flat cables [4] to the
actuators [5], connect them until a click
sound is heard.
Fig. 9-6
Notes:
• When installing the flat cables [4], do not
push them in strongly.
• When installing the flat cables [4], be
careful not to insert them at an angle.
• Do not apply pressure to or damage the
edge of the flat cables [6].
Fig. 9-7
Notes:
• When installing the harnesses, be careful
not to connect each different USB
harness.
CN112: White USB harness
(The harness of the control panel)
CN113: Black USB harness
(The harness of the USB Hub
board)
Fig. 9-8
To Next Page
Loading...
