11
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
FIRMWARE UPDATING
11 - 23
(12) Perform [HS-49] and carry out the system firmware updating if necessary.
P. 11-2 "11.2 Firmware Updating with USB Device"
(13) Remove the USB storage device.
Notes:
• When the normal HDD is installed in the equipment, shut down the equipment and then check
that it reboots normally. This is the end of the process.
• When the security HDD is installed in the equipment, perform the procedure [B] sequentially.
[B] Restoring the encryption Key and License
(1) Perform [HS-73] and press [Key Backup/Restore].
(2) Press the [Key], [ADIKey] or [License] and then [Execute].
* Recover the encryption Key or License to which "KeyBroken" or "KeyNulll" is indicated in the
FROM row.
* When the recovery succeeds, the indication in the FROM row will change to "OK".
P. 5-41 "5.13.3 Functions"
(3) Shut down the equipment and then reboot it. Confirm that it starts normally.
(11) Connect the jumper [2] to CN106 on the SYS
board [1]. Reattach the removed covers and
plug in the power cable.
Fig.11-14
CN106
[
2
]
[
1
]
To Next Page
Loading...
