General safety instructions
3.7 Structural changes at the machine
For safety reasons, no unauthorised changes may be made to the machine - this
also applies to welding work on bearing parts.
All planned changes must be authorised in writing by the company (specify the
address and if appropriate the name of a person responsible).
Use only original replacement parts / original wearing parts / original accessories.
These parts are specially designed for the machine. With bought-in parts there is no
guarantee that they have been designed and built to comply with the stress and
safety requirements of the machine.
Parts and special fittings which were not supplied by us are also not approved by us
for use in/on the machine.
3.8 Environmental protection
During all work on and with the machine, the regulations for waste avoidance and
proper waste disposal or recycling must be observed.
In particular when setting up, servicing and withdrawing the machine from operation,
make sure that substances which can contaminate ground water - such as
Grease
Hydraulic oil
Cleaning fluids
do not soak into the ground or enter the drainage system. These substances must
be caught, stored, transported and disposed of in suitable containers.
To Next Page