Transfluid DB 2090 ST - Setting up the Machine

34
5 Setting up the machine
When setting up the machine, you must observe the following safety instructions in
order to avoid lethal injury, damage to the machine and other material damage.
WARNING!
The steps involved in setting up the machine - assembly and
installation - may only be carried out by qualified persons taking
into account the safety instructions.
Before you begin setting up the machine, it must be checked for
any damages incurred during transport.
Make sure that only authorised persons remain in the machine's
operating area and that no other persons are put at risk during
set-up.
All machine connections - cables, hoses and pipes - must be laid
such that there is no danger of tripping over them.
Observe the provisions for the fuels, lubricants, process
materials used.
Read the chapter "General safety instructions"
Watch out for the following special dangers when setting up the machine.
DANGER!
By not correct installation, particularly by not correctly
implemented electrical connections, it exists the danger of
heavy injuries and mortal danger!