Spart up the machine
7.3 Reference drive of the machine
After the machine was started up, the machine must be referenced. Go on as
follows for this:
1. After everyone start up of the machine the
safety scanner executes a self check. For this
the protection field of the safety scanner must
be once injured.
The scanner is ready for operating, if the
red LED - control light goes out and the
green LED - control light goes on.
2. Press the button Referencedrive / Automatic
Start., in order to start the reference drive of
the machine.
The Reference point at the rear end of the
machine body is started.
After everyone start up of the machine, the off-set bend device
must be referenced!
To Next Page