Transfluid DB 2090 ST - Page 5

Content
5
6.3.2 Menu "General" ............................................................................................... 43
6.3.3 Menu „Manual“ ................................................................................................. 44
6.3.4 Menu „Automatic“ ............................................................................................ 46
6.3.5 Menu „Data block“............................................................................................ 47
6.3.6 Menu „Tool Table“ ........................................................................................... 50
6.3.7 Menu „Pressure value“ ..................................................................................... 53
6.3.8 Menu „Error“..................................................................................................... 54
7 Start up the machine ............................................................................ 55
7.1 Checks before start up the machine .................................................................. 57
7.2 Start up the machine ........................................................................................... 58
7.3 Reference drive of the machine .......................................................................... 59
7.4 Checks after the first start up ............................................................................. 60
7.5 Examination of the safety devices ..................................................................... 61
8 Operation (setting-up and production) ............................................... 62
8.1 Setting-up and adjusting of the machine ........................................................... 63
8.1.1 Setting up of the bending tools ........................................................................ 64
8.1.2 Mandrel adjustment ......................................................................................... 71
8.1.3 Adjustment of the wiper die (Special equipment) ............................................. 73
8.1.4 Clamping pressure adjustment ........................................................................ 76
8.2 Bending with the machine .................................................................................. 77
8.2.1 Operating modes ............................................................................................. 77
8.2.2 Safety area of the outer support ...................................................................... 78
8.2.3 Bending in manual operating mode ................................................................. 79
8.2.4 Bending in automatic operating sequence ....................................................... 89
8.2.5 Handling after activating the emergency stop .................................................. 95