Troxler 3430 Plus - Auto-Store; Active Project Selected

8–12
AUTO-STORE
The Auto-Store function automatically stores sample data upon
completion of a measurement. The data is stored under the active
project, using a sequential sample ID number. When a new project
is created, the sample ID number for the Auto-Store function starts
at 1 and is incremented each time a new measurement is stored
automatically or manually.
To access the Auto-Store function, press 〈8〉 at the Projects menu
shown on page
8–2. The gauge displays:
 To return to the Projects menu without changing the Auto-
Store status, press
〈ESC〉.
 To turn the Auto-Store function on, press 〈1〉.
 To turn the Auto-Store function off, press 〈2〉. The gauge
updates the Auto-Store status, displays a brief confirmation
message, and returns to the Projects menu.
ACTIVE PROJECT SELECTED
If the operator attempts to enable the Auto-Store function and a
project has been selected as active, the gauge enables the Auto-Store
function, briefly displays the confirmation message shown below,
and then returns to the Projects menu.

 
 
   

  
 
   