Model 3430 Plus & 3440 Plus
OUTPUT PROJECT
The Output Project function within the Projects menu allows the
operator to print (or upload) project data stored in the gauge to a
computer or serial printer connected to the serial port, or to a USB
printer or flash drive connected to the USB port. To select the
output destination, see page 8–10.
NOTE
The USB port is included only on Model 3440 Plus
gauges.
To output project data via the 9-pin serial port, connect a serial
cable to the port. Ensure that the serial cable meets the pinout shown
on page F–6. An optional serial cable, PN 113128, is available from
Troxler. Connect the serial cable to the printer (or computer) serial
port.
NOTE
To upload data to a computer, use the HyperTerminal
application available from the Windows
Accessories
menu. This application can be used to transfer data
from the gauge to the computer. For more information
on setting up HyperTerminal to communicate with the
gauge, see
Appendix H.
To output project data to a USB printer via the USB port, connect a
USB cable to the USB port and connect the cable to the USB
printer. To output project data to a USB flash drive, connect the
flash drive directly to the USB port.
NOTE
The opening for the USB port will accept a device with
maximum dimensions of 10 mm (0.40 in.) high by
29 mm (0.79 in.) wide.
NOTE
A list of compatible USB devices is available at:
www.troxlerlabs.com/PRODUCTS/PRODLIT/otherlit.shtml
To Next Page
Loading...
Need help?
General
