Troxler 3430 Plus - Chapter 3 Getting Started; Control Panel; Source Rod Positions; Daily Inspection

Model 3430 Plus & 3440 Plus
3–1
CHAPTER 3
GETTING STARTED
This chapter provides details on getting started with the Model 3430
Plus and 3440 Plus Surface Moisture-Density Gauges. It describes
the gauge keypad, and provides instructions for conducting daily
gauge inspections, turning the gauge on, and setting up the gauge.
CONTENTS
Gauge Illustration ......................................................................... 3–2
Control Panel ................................................................................ 3–3
Source Rod Positions .................................................................... 3–5
Daily Inspection ............................................................................ 3–6
Turning the Gauge On .................................................................. 3–7
Setup ............................................................................................. 3–9
Setup Menu ............................................................................ 3–9
Extended Menu .................................................................... 3–11
Measurement Mode .............................................................. 3–15
Project Function ................................................................... 3–16
Display Backlight ................................................................. 3–16
3. GETTING STARTED