STORE A NEW TARGET VALUE
To store a new target value, press 〈5〉 at the Target Value menu. At
the prompt, use the number keys to enter the target value (between
20.0 and 200.0). Press the 〈ENTER/START〉 key. The gauge
displays:
To enable and use this value without storing it for later use,
press
〈NO〉 key. The gauge enables the value and returns to the
Ready screen.
To enable the value and store it for later use, press the 〈YES〉
key. The gauge displays:
The gauge can store the value in one of four memory cells.
Storing a new value in a cell erases the old value. Use the
number keys to store the value. This will replace any stored
values that were previously associated with the memory cell.
The gauge stores the target value, enables it for use, and returns
to the Ready screen.
DISABLE THE TARGET VALUE
To disable the target value, press 〈6〉 at the Target Value menu. The
gauge disables the target value and returns to the Ready screen.
NOTE
The gauge can be used with the target value disabled. In
this case, no percent compaction value will be displayed.
To Next Page
Loading...
Need help?
General
