Troxler 3430 Plus - New Standard Count

Model 3430 Plus & 3440 Plus
4–3
NEW STANDARD COUNT
When taking a new standard count, the gauge displays:
Place the reference standard block on the standard count site. As
shown in Figure 4–1, place the gauge on the reference standard
block, with the right side (keypad side) of the gauge against the
metal butt plate.
NOTE
Ensure that the source rod is in the standard (SAFE)
position and is securely seated by firmly tapping down
on the handle of the source rod.
Figure 4–1. Standard Count Position
  
   
   
 
4. USING THE GAUGE