WINDOWS HYPERTERMINAL
To print (upload) data from the gauge to a computer equipped with
a Microsoft Windows XP operating system, use the HyperTerminal
program as described in the following sections.
HYPERTERMINAL SETUP
To configure the Windows HyperTerminal program and set up a
dedicated icon to transfer data from the gauge, perform the
following steps:
1.
Click on the Start button, select the Programs menu, and then
the Accessories folder. Select the Communications
subfolder, and then select the HyperTerminal icon.
2.
From the HyperTerminal window, double-click on the
Hypertrm icon. The Connection Description window is
displayed. This window is used to set up a new connection.
3.
In the Name box, enter a name (for example, Troxler Data) for
the new connection. Select an icon to use for the connection,
then click OK. The Connect To window is displayed.
4.
In the Connect To window, do not enter a telephone number.
Instead, select Direct to Com1, Direct to Com2, Direct to
Com3, or Direct to Com4, depending upon the computer.
The COM# Properties window is displayed, where # is the
number of the selected COM port.
5.
Configure the Port Settings as follows:
Bits per second 9600
Data bits 8
Parity None
Stop bits 1
Flow control Xon-Xoff
To Next Page
Loading...
