Troxler 3430 Plus - Taking Nomograph Measurements

5–14
TAKING NOMOGRAPH MEASUREMENTS
When the Nomograph function is enabled, the gauge can be used to
take thin-layer overlay measurements. Press
〈ENTER/START〉 to
begin the test. The gauge displays:
After counting down to zero, the display is:
This test may be stored as any other test measurement. The recall
function and/or printout will show that the Nomograph function was
used.
NOTE
The Nomograph function should be disabled before
taking any measurements not requiring this function.
  
  
  
 
 
  