If a project is active (see Chapter 8) and the Auto-Store
function (see page 8–12
) is enabled, press 〈ESC〉 or
〈ENTER/START〉 to continue. For each measurement, the
gauge can store a location description of up to 12
characters, as well as a note of up to 15 characters. For an
Asphalt mode measurement, the gauge can also store
location with respect to the centerline (left, right, or
neither), and the distance from the centerline. Follow the
prompts to enter location information and/or a note.
If a project is active but the Auto-Store function is not
enabled:
Press 〈STORE〉 to store the results. Follow the prompts
to enter location information and/or notes. For more
information on storing results manually, see page
8–14.
Press 〈ESC〉 to return to the Ready screen without
storing the results. Note that, until another measurement
has been taken, the results can be recalled as described
on page
4–17.
✓
Lift the gauge from the test site using the source rod handle.
This returns the source rod to the SAFE position. When not
taking readings, always keep the source rod in the SAFE
position.
To Next Page
Loading...
