TSC TTP-247 Programming Manual

TSC AUTO ID Technology Co., Ltd. 129 Copyright 2013 All Rights Reserved.
 COPY
Description
Copy the existed file from CARD to FLASH.
Syntax
COPY [memory ID of source,]"filename of source",[memory ID of new file,]"new filename"
Parameter
Description
memory ID of source
Optional.
ID
Memory device
Omitted
DRAM
F
FLASH
E
CARD
source filename
The file in CARD which you want to copy to on board FLASH.
memory ID of new file
Optional.
ID
Memory device
Omitted
DRAM
F
FLASH
new filename
The new filename you want to use in the on board FLASH.
Note: This command has been supported since V6.78 EZ and later firmware.
Example
See Also
DOWNLOAD, EOP, OPEN, FREAD$(), EOF, LOF(), SEEK, CLOSE
Sample Code
DOWNLOAD "DATA_D.DAT",105,We stand behind our products with one of the most comprehensive support
programs in the Auto-ID industry.
DOWNLOAD "TEST.BAS"
KILL F,"*"
COPY "DATA_D.DAT",F,"DATA_F.DAT"
OPEN "DATA_F.DAT",0
SEEK 0,0
data$=FREAD$(0,LOF("DATA_F.DAT"))
CLOSE 0
SIZE 4,0.5
GAP 0,0
CLS
BOX 10,10,800,100,2
BLOCK 15,15,790,90,"0",0,8,8,20,2,data$
PRINT 1
EOP
TEST
Result
203 dpi
300 dpi

TSC TTP-247 Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Resolution	203 dpi
Max Print Width	4.09" (104 mm)
Processor	32-bit RISC CPU
Weight	2.5 kg
Max Print Speed	7 ips
Memory	8 MB SDRAM, 4 MB Flash
Interface	USB 2.0, Serial
Ribbon Capacity	300 meters
Label Width	1" (25.4 mm) ~ 4.33" (110 mm)
Label Thickness	0.06 mm ~ 0.19 mm
Power Supply	External Universal Switching Power Supply
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Operating Humidity	25% to 85%, non-condensing
Certifications	CE, FCC, UL, CCC