27
27
Cruise control ‘Res/+’ switch operation:
Gentle push of cruise control switch knob towards
‘Res/+’ position activates the ‘Res/+’ switch.
• While cruise control is in standby mode, push the
switch knob to ‘Res/+’ position to activate the
cruise control.
- In case cruise control set speed is stored
previously, the vehicle will take the stored
speed as cruise control set speed.
Conditions for turn ‘ON’ cruise control:
Cruise control can be switched ‘ON’ only when the
following speed limit conditions are met at respective
gear positions.
Gear Position 1st 2nd 3rd 4th 5th 6th
Minimum set
speed (km/h)
25 30 40 45 50 50
Maximum set
speed (km/h)
120
Rider has to be above the minimum speed of the
respective gears to resume the speed.
Note
- In case cruise control set speed is not stored
previously, the system takes current vehicle
speed as cruise control set speed.
• While the cruise control is turned ‘ON’ (cruise
state), you can increase already set cruise speed
in the following manner:
- Short press (less than 1.5 secs) the knob to
increase the vehicle speed by 1 km/h from
set speed.
- Long press (more than 1.5 secs) the knob to
increase the vehicle speed by 5 km/h from
set speed rounded to the nearest digit.
To turn ‘ON’ the cruise control
• Press the cruise control switch when the vehicle
speed is more than the minimum allowable
speed limit. This will turn ‘ON’ cruise control and
set speed will happen simultaneously.
- If the cruise control switch is pressed when
the vehicle speed is lesser than the minimum
allowable speed limit, the cruise control will
enter into ‘Standby mode’ and you need
press the switch to ‘Set/-’ position after
crossing the minimum allowable speed limit
to enable the cruise control.
To Next Page
Loading...
Need help?
General
