Note:
- The snap ring C(25) should be securely seated in the groove and the press-processed side turned
towards the outer side.
- When pushing the bearing (6305, 6307) into the gear(20), be careful only to push their inner races.
- Every time a gear is installed, its smooth rotation should be checked.
(7) REAR PTO counter shaft mechanism
a. REAR PTO shaft
b.REAR PTO shift stay
20.Gear, helical 11-14 21.Bearing(6305) 22.Bearing(6307) 25.Snap ring(25) 26.Snap ring(62)
Note : The snap ring C should be securely seated in the groove and the press-processed side turned
towards the outer side.
When installing the O-ring to the PTO sleeve and the oil seal, take care not to damage it or
allow to fall.
5-44
Fig.5-83.Stay PTO shift
Fig.5-82
1.Shaft PTO
2.Snap ring
6306HL1 6307HL1
O-ring
Oil seal
Fig.5-81
To Next Page
Loading...
