(8) Drive pinion Sub assembly
Note:
a.Apply oil to the drive pinion and related parts ahead of time. Then install them and tighten the
assembly to the specified torque.
b.Be sure that the starting torque of the drive pinion meets the specified level.
Starting torque is 0.11-0.13 Kgf.m (0.576 ~ 0.792 ft.lbs)
c.After the starting torque has been adjusted to the specified level, crimp the lock of the nut at one
point as illustrated.
d. Be sure that these parts should turn smoothly
When the drive pinion or the ring gear has been replaced, the proper number of shims to be installed
should be determined based upon the following procedure :
3.Washer(30X46X3) 4.gear spur 24T 5.Hub(30x62x19), 6.Coupling
7. Snap ring (shaft) ⑥.Gear super 30T,4WD 12.needle bearing
19.Hub(35X51X21),Coupling(52x72x18) 19-01.pinion drive 11T 22.Nut(M40x1.5)
23.Taper roller bearing 24.Metal pinion 32.gear spur 46T
5-45
Fig.5-84
(1) Drive pinion (2) Tapered roller bearing (3) Drive pinion metal
(4) Tapered roller bearing (5) Nut (M40X1.5)
Fig.5-85
To Next Page
Loading...
